Hebei 12v 10A Peltier Thermoelectric CoolerProduct has been kindly sponsored by taydaelectronics.com
|
|
product specificationsGeneral
Type: Peltier Thermoelectric Cooler Architecture: For all electronics Maximum Operating Temperature: 138°C Life Expectancy: 200000 hours Failure rate based on long-term testing: 0.2% Module Resistance (if hot side temperature is 25°C): 1.08Ω Module Resistance (if hot side temperature is 50°C): 1.24Ω Delta Maximum Temperature (if hot side temperature is 25°C): 66°C Delta Maximum Temperature (if hot side temperature is 50°C): 75°C Wire Type: AWG 20 Power Operating Voltage: +12 volts maximum Operating Current: 10A maximum Operating Power: 120W maximum Maximum Voltage (if hot side temperature is 25°C): 15.2 volts Maximum Voltage (if hot side temperature is 50°C): 17.4 volts Maximum Current (if hot side temperature is 25°C): 10.5A Maximum Current (if hot side temperature is 50°C): 10.5A Maximum Power (if hot side temperature is 25°C): 85W Maximum Power (if hot side temperature is 50°C): 96W Weight and Size Dimensions Product Weight: Wire Diameter: 1.2 mm Wire Length: 30 cm Product Size (L x W x H): 40 x 40 x 3.4 mm |
product reviewA peltier cooler, also known as a thermoelectric cooler is an interesting device, now used in many modern electronic devices like air conditioning, coolers or in a powerful computer system. I really like using this product due to these following reasons:
1. This module can be used to generate electricity and act as a cooler/heater with a wide range of current (0A - 10A) which you can supply to it and a wide range of voltage (0 - 10 volts) which you can power it up with. 2. This product has the ability to last for long hours (200000 hours) in a project box or in a cooling system, but it is important that you power this module with a heatsink on the hot side as it will damage your module if you do not. I recommend also adding some sort of thermal insulating medium, like thermal paste, thermal glue or thermal tape to assist with the heat absorption to your heatsink, as this module can get pretty hot rapidly. 3. The wire which is attached to the module is a high quality standard of electrical wire (AWG 20), where it is durable to high amounts of tensions and bends. The wire length is 30 cm, good enough for attaching it to other micro controllers, components or boxes. 4. The product size itself is very thin in size and in the shape of a square, so being able to put this onto a heatsink can be easy to do as heatsinks for certain dimensions can be hard to find sometimes. datasheet
| ||
tayda electronics product page
Check out the product here: https://www.taydaelectronics.com/thermoelectric-cooler-peltier-12v-10a.html
